Slime 40046 - Elite Heavy Duty Inflator Manual

Slime 40046 - Elite Heavy Duty Inflator Manual

Also See for 40046:

Advertisement

Slime 40046 - Elite Heavy Duty Inflator Manual

Overview

warning ATTENTION! READ ALL INSTRUCTIONS CAREFULLY FAILURE TO FOLLOW WARNING INSTRUCTIONS CAN RESULT IN FIRE, PERSONAL INJURY OR PROPERTY DAMAGE.
Overview
DIGITAL GAUGE

  • PSI, BAR, kPa

INFLATOR

  • Powerful direct-drive motor
  • Overheat Auto Shut-Off Safety Feature
  • Air-cooled motor

REMOVABLE MAGNETIC LED LIGHT

  • Bright, mobile work light for nighttime emergencies
  • Twist on, Twist off

POWER SOURCE

  • Plugs into 12V power outlet

EXTENSION COIL AIR HOSE

  • Connects to built-in air hose for extra reach
  • Twist-tight valve

TECH SPECS

TECH SPECS
* (0-35 PSI, Standard Tire: P195/65 R15)


HOT

  • DO NOT HOLD IN HAND WHILE OPERATING
  • PLACE INFLATOR ON A HARD, CLEAN SURFACE.
  1. DO NOT run vehicle while inflator is operating. You may need to be in "accessory" or "on" position. Please make sure emergency brake is set and car is in park.
  2. DO NOT use inflator continuously for more than 10 minutes. Allow unit to cool approximately 25 minutes between uses. Do not leave inflator unattended.
  3. ALWAYS use a pressure gauge to check tire pressure. DO NOT OVERINFLATE!
  4. Read all instructions thoroughly before use. Failure to follow warning instructions can result in fire, injury to persons or property damage.
  5. For use with 12 volt DC power outlets rated 15 amps or higher. Do not use with older 8 amp cigarette lighter receptacles.
  6. Keep inflator out of reach of children.

INFLATE TIRES

  1. Screw air hose connector onto tire's valve stem.
  2. Plug power cord into 12 volt accessory power outlet.
  3. Press on switch to turn on inflator. Inflate tire to manufacturer's recommended air pressure.
    * When proper pressure is reached, press off switch to turn off inflator. Unplug power cord and remove air hose connector.

*NOTE: Correct tire pressure can be found in vehicle owner's manual or on driver's side door jamb.

TROUBLESHOOTING

Inflator does not turn on

  1. Check the power plug and push it firmly into the receptacle, twist back and forth.
  2. Check receptacle and plug terminals for dirt, or debris. (Use a non-conductive probe, not fingers or metal).
  3. Check vehicle power outlet fuse, should be 15 amps minimum.
  4. Check the fuse, located in the plug adaptor, it may have blown. Unscrew the tip of the plug adaptor, remove fuse, and inspect (if necessary, replace fuse with one of the same amperage).

Inflator runs but does not inflate

  1. Be sure the air hose connector is tightly screwed onto the valve stem.
  2. Check tire for leaks. Check hose for breaks and leaks at fittings.

Inflator runs slowly

  1. The inflator may have overheated from excessive use. Shut it off and allow it to cool for 25 minutes.
  2. The voltage may be too low. Check the condition of your vehicle's battery.

NOTE: If tire is totally deflated, it is possible that the tire could separate from the rim allowing air to leak out when trying to inflate. In the event this occurs, it may be necessary to jack up the tire prior to inflation.
Dispose of this product at an e-waste recycling collection point or facility. Do not place in the trash or standard recycling receptacle.

QUESTIONS OR COMMENTS: Call +1-805-489-0490 or visit www.slime.com
ITW Global Tire Repair • 125 Venture Drive, Suite 210, San Luis Obispo, CA 93401 USA
Slime® is a trademark of Illinois Tool Works, Inc., registered in the U.S. and other countries.

Documents / Resources

References

Download manual

Here you can download full pdf version of manual, it may contain additional safety instructions, warranty information, FCC rules, etc.

Download Slime 40046 - Elite Heavy Duty Inflator Manual

Advertisement

Need help?

Need help?

Do you have a question about the 40046 and is the answer not in the manual?

Questions and answers

Table of Contents