Table of Contents
Advertisement
ALTERNATE ON/OFF SWITCH INSTALLATION
WIRING THE FIREPLACE
cian.
DISCONNECT REMOTE CONTROLS IF YOU ARE ABSENT
FOR EXTENDED TIME PERIODS. THIS WILL PREVENT AC-
CIDENTAL FIREPLACE OPERATION.
An ON/OFF switch and wire assembly are provided. They are in-
cluded in the instruction packet.
Do not cut wire or insulation on metal edges.
Notice: Refer to surround panel installation section in the
DF(20,28)MBL
1.
Find the coiled low voltage wire assembly and ON/OFF switch
located in the instruction packet.
nals on the front terminal block of the gas valve. See Figure
21.
3.
Run the low voltage alternate switch wires up the back of the
right or left surround panel. Then secure the wires with wire
clips provided. See Figure 20.
ON/OFF
SWITCH
then install the ON/OFF switch into the switch bracket.
5.
Connect the low voltage wires from the gas valve to the
ON/OFF switch.
access to the ON/OFF switch.
26497-6-0511
WARNING
WARNING
WIRING FROM
MILLIVOLT GAS
VALVE
6.
Attach the surround panel assembly to the insert. Place the
surround panel assembly against the face of the insert and
align the lower retaining tabs with the notches on the insert
-
sides. Lift the surround panel assembly slightly until the bot-
on the insert. This secures the surround panel assembly to
the insert without screws.
WIRES FROM ON/OFF
SWITCH INSTALLED IN
LEFT OR RIGHT SIDE
SURROUND PANELS
TH/TP
TP
TH
-
NOTE: TO OPERATE INSERT WITH SIDE PANEL
ON/OFF SWITCH, BE SURE TO PLACE THE MAIN
SWITCH (TO THE RIGHT SIDE OF GAS VALVE) TO "
POSITION
-
-
Figure 21
OFF
"
Page 21
Advertisement
Table of Contents
