Table of Contents
Advertisement
to determine where the unit is to be installed and whether
optional accessories are desired. Gas supply piping should
also be planned at this time.
2. A raised platform of combustible or non-combustible
material.
all four perimeter edges on the bottom of the unit.
This unit is designed to be installed in a zero-clearance en-
closure. This means the combustible material can come in
Built-In Fireplace Installation
10 through 12. Follow the instructions below to install the
Frame in rough opening. Use dimensions show in Figure 3
for a conventional rough opening. Use dimensions shown in
Figure 4 for corner rough opening. Be sure to provide gas
Rough Opening for Installing in Wall
1" TO 6" FROM BACK
25mm TO 152mm
ELECTRICAL RECEPTACLE
VFP20IN
VFP28IN
Page 10
BUILT-IN FIREPLACE INSTALLATION
Figure 3
A
13 3/4"
16 3/4"
installed on a metal or wood panel extending the full width
and depth of the unit.
At this point, you should have decided what components
be located. If this has not been done, stop and consult your
dealer for assistance with this planning.
sembly.
1. Gas line connections must be made at this time. When
facing the appliance, the gas supply will enter on the
right-hand side. See "Gas Supply" pages 15 to 16.
Insert" on Page 8.
5. If used, the surround panel assembly is installed after
electrical connection completed. See Page 22. Refer to
instructions included with the surround panel kit.
-
Rough Opening for Installing in Corner
C
B
27 3/4"
18 1/2"
30 1/2"
22 1/2"
2 5 5 / 8 "
6 5 0 . 9 m m
B
5 1 1 / 4 "
(1 3 0 1 . 8 m m )
Figure 4
C
D
36 1/4"
36 1/4"
26497-6-0511
Advertisement
Table of Contents
