Hydraulic Thermostat Lighting Instructions - Empire Comfort Systems VFP28IN3 L Series Installation Instructions And Owner's Manual

HYDRAULIC THERMOSTAT LIGHTING INSTRUCTIONS

FOR YOUR SAFETY READ BEFORE LIGHTING
WARNING:
B. BEFORE LIGHTING
WHAT TO DO IF YOU SMELL GAS
1. STOP! Read the safety information above.
cable).
4. Push in gas control knob slightly and turn clockwise
to "OFF". Do not force.
smell gas, go to the next step.
6. Find pilot - the pilot is in front
of the rear log.
7. Turn gas control knob
counterclockwise
"PILOT."
8. Push in gas control knob all the way and hold in. Repeat-
a match to light pilot). Continue to hold the control knob
knob and it will pop back up. Pilot should remain lit. If it
2. Turn off all electric power to appliance if service is to be
Page 28
LIGHTING INSTRUCTIONS
to
TO TURN OFF GAS TO APPLIANCE
C. Use only your hand to push in or turn the gas control
goes out, repeat steps 4 through 8.
immediately call your service technician or gas
-
supplier.
the gas control knob to "OFF" and call your service
technician or gas supplier.
9. Attention! Gas control has an INTERLOCK latching de-
vice. When the pilot is initially lit and the safety magnet
device becomes operative. If the gas control is turned to
off, the pilot cannot be relighted until the safety magnet
be an audible "click" when the safety magnet in the gas
control is de-energized. Pilot can now be relighted.
Repeat steps 4 through 8.
10. Turn gas control knob counterclockwise
"5".
"5" to "1".
3. Push in gas control knob slightly and turn clockwise
to "OFF". Do not force.
to
26497-6-0511