Package Contents; Operating Conditions; Limited Warranty - ironLogic Matrix II Wi-Fi User Manual

Matrix II Wi-Fi
8. CONNECTION BETWEEN NETWORK AND STANDALONE MODES
Note 1: When the power is back after a power failure, the Controller remains in the mode that was
active before the failure. Exception: Add/Erase Keys modes do not persist after power is back on, but
normal operation mode is reactivated instead.
Note 2: When switching from standalone mode to network mode, the control software usually
overwrites existing keys database with the new keys database from the control computer. Therefore,
we recommend saving existing keys database before connecting the controller to control software,
so it can later be restored, or exported into control software.
Note 3: If while in network or Web mode, a Master key is presented to the controller, most probably
nothing happens, because the network software removes all existing Master keys and forbids
creating new keys. To enter a new key into networked system while in network mode, use the control
software.
Note 4: If after the controller is configured in standalone mode, it will need to be accessed via
software (e.g. GuardCommander) over the network, then please use the Web interface to configure
the controller for network operation.
9. UPDATING OR RESTORING FIRMWARE VIA USB
Controller may be connected to a PC via USB interface in case if firmware update is not possible via
Web interface. Once the device is connected to a PC with a USB cable, it is powered from USB bus,
hence external power supply is not needed.
Once connected, the system will recognize a new serial port. Drivers installation might be required,
which can be found on www.ironlogic.me website. Software utility for controller's firmware update is
also available on this website.

10. PACKAGE CONTENTS

Matrix II Wi-Fi device ............ - 1 pce.
Mounting kit........................- 1 pce.
User manual .......................- 1 pce.

11. OPERATING CONDITIONS

Ambient temperature:..........................-40°С... +50°С.
Humidity:..........................................not exceeding 98% at 25°С.
Device specifications may not fully be as specified, when operating under non-recommended
conditions.
The controller should not be operated where the following exists: atmospheric precipitation, direct
sunlight, sand, dust and moisture condensation.

12. LIMITED WARRANTY

Device is covered by limited warranty for 24 months.
The warranty becomes void if:
this Manual is not followed;
-
device has physical damage;
-
device has visible traces of aggressive chemicals exposure;
-
- device circuits have visible traces of tamper by unauthorized parties.
While covered, the Manufacturer will repair the device or replace any broken parts, free of charge,
where fault is caused by manufacturer's defect.
Product lifetime – 6 years.
www.ironlogic.me
Page 19