Service And Speed/Duplex; Bandwidth Control - Dynamix HP HP-51M User Manual

Homepna3.1 coax mdu master bridge
Table of Contents

Advertisement

DYNAMIX HP-51M Coax MDU Master Bridge User's Guide

Service and Speed/Duplex

Change 'Service' to enable or disable the port. This setting open or close the related Ethernet switch port in EP.
Default setting in field 'Speed/Duplex' is 'Auto' states for auto-negotiation.

Bandwidth Control

Consider port HCNA as the network backbone and refer the following diagram to set up bandwidth control
parameters in EP's Ethernet switch (Regards as Hardware bandwidth control, works for both upstream and
downstream). The maximum allowed rate should be the setting value multiplied by 64Kbps. If maximum rate
exceeds 100Mbps (as the value 1563), there will be no bandwidth control at all.
14

Advertisement

Table of Contents
loading

Related Products for Dynamix HP Dynamix HP-51M

Table of Contents