Table of Contents
Advertisement
Installing an SFF hot-plug drive
Installing an SFF hot-plug drive
CAUTION: To prevent improper cooling and thermal damage, do not operate the server unless all bays are populated
CAUTION:
with either a component or a blank.
Procedure
Procedure
1. If installed, remove the front bezel .
2. Remove the drive blank.
3. Prepare the drive.
4. Install the drive.
5. If removed, install the front bezel .
6. Determine the status of the drive from the drive LED definitions .
The installation is complete.
To configure arrays, see the HPE Smart Array SR Gen10 Configuration Guide at the Hewlett Packard Enterprise website
Hewlett Packard Enterprise website .
Installing an SFF hot-plug drive
77
Advertisement
Table of Contents
Troubleshooting
