Table of Contents
Advertisement
12. Connect the drive cables .
13. Install the access panel .
14. Install the server into the rack .
15. Connect all peripheral cables to the server.
16. Connect the power cords:
a. Connect each power cord to the server.
b. Connect each power cord to the power source.
17. Power up the server .
18. If removed, install the front bezel .
The installation is complete.
To configure arrays, see the HPE Smart Array SR Gen10 Configuration Guide at the Hewlett Packard Enterprise website
Hewlett Packard Enterprise website .
Installing an LFF non-hot-plug drive
75
Advertisement
Table of Contents
Troubleshooting
