Table of Contents
Advertisement
Camera Management
4.1 Add/Edit Camera
4.1.1 Add Camera
The network of the NVR should be set before adding IP camera (see 13.1.1 TCP/IP Configuration for details).
Refer to the pictures below. Click Add Camera in the setup panel or
window as shown below. You can quickly add or add the IP camera manually.
Quickly Add
Check the cameras and then click "Add" to add cameras. Click
"Default Password" to set the default username and password of each camera.
Add Manually
Enter the IP address or domain name (click
the IPC in the window and then click "OK" button), port, username and password of the camera and then select the protocol. Click "Test" to test
the effectiveness of the input information and then click "Add" button (you can input one camera's information or above such as IP address,
4 Camera Management
in the top right corner of the preview window to pop up the "Add Camera"
to edit the camera's IP address, username and password and so on. Click
in the IP address column to pop up the domain name input window, enter the domain name of
13
NVR User Manual
Advertisement
Table of Contents
