Advanced Configuration; Encode Parameters Setting; Record Mode; Manual Recording - Speco N16NRD User Manual

Record & Disk Management
Click "All" to set all week recording; click "Reverse" to swap the selected and unselected time in a week; click "Clear All" to clear all the selected
area in a week.

7.1.3 Advanced Configuration

Click StartSettingsRecordAdvanced to go to the following interface. Enable or disable cycle record (cycle record: the earliest record data will
be replaced by the latest when the disks are full). Choose the record stream. Set the pre-alarm record time, post-alarm record time and expiration
time of each camera and then click "Apply" to save the settings.
Pre-alarm Record Time: set the time to record before the actual recording begins.
Post-alarm Record Time: set the time to record after the actual recording is finished.
Expiration Time: set the expiration time for recorded video. If the set date is overdue, the recorded data will be deleted automatically.

7.2 Encode Parameters Setting

Click StartSettingsRecordEncode Parameters to go to the interface as shown below.Set the encode, resolution, FPS, GOP, bitrate type,
quality, max bitrate and audio of main stream for each camera in "Event RecordingSettings" and "Schedule RecordingSettings" interfaces. Click
"Apply" to save the settings. You can set the record stream of each camera one by one or batch set them for all cameras.

7.3 Record Mode

7.3.1 Manual Recording

Method One: Click
Method Two: Go to the live view interface and then click the right-click menu "Manually Record On" in the camera window or click
tool bar under the camera window to start recording.
on the tool bar at the bottom of the live view interface to enablerecording of the camera.
 
Note: Click Start Settings Record
interface. Click "Apply" to save the settings.

Mode Settings and then set the manual record time in the
34
NVR User Manual
on the