Table of Contents
Advertisement
Safety - Section 2
Page 2-6
The welding "Caution" plate WA9713 is located in the
cab above the windshield. These instructions MUST be
followed when welding is done on the truck to avoid
damage to the ATEC components.
. . . . . . . . . . . . . . . . . . . . . . . . . . . . .
A ROPS/FOPS Warning plate is located on the right
side of the cab above the windshield. It specifies that
the structure as manufactured meets SAE specifica-
tions and warns that these specifications may be im-
paired if subjected to any modifications or damage.
WA9779 Caution decal is located in the cab on the back
of the sunvisor and specifies that during first four hours
of operation, the Truck Speed SHOULD NOT Exceed
25 MPH (40 KPH) in order to properly break-in the oil
brake seals.
. . . . . . . . . . . . . . . . . . . . . . . . . . . . .
On the right side of the operator's instument panel is a
decal with two WARNINGS.
The Warning on the left specifies that wheel brake lock
is not to be used for parking. If engine is not running,
brake pressure will bleed down allowing brakes to be
released. Wheel Brake Lock should be used only at the
shovel or dump, or for an emergency.
. . . . . . . . . . . . . . . . . . . . . . . . . . . . .
OM2012.2
Warnings and Cautions
Advertisement
Table of Contents
