Table of Contents
Advertisement
OM2012.2
Warnings and Cautions
WA9712 Warning plate is attached to both the hydrau-
lic and fuel tank. For the safety of technicians who may
be working on the truck with the body in the raised
position, they are warned to make sure safety pin
(body-up retaining pin) is in position.
. . . . . . . . . . . . . . . . . . . . . . . . . . . .
Danger plate WA2892 is attached to each suspension
cylinder as well as steering and brake accumulators.
This plate contains instructions for releasing internal
pressure prior to disconnecting any hydraulic lines or
hardware.
TY5888 Warning decal is applied to the Steering accu-
mulator and both Brake accumulators to warn servic-
ing personnel of both high gas pressure and hydraulic
pressure. Be certain pressures are released before
disconnecting any lines or disassembly of the cylin-
ders. Refer to the service manual, Sections "J" and "L"
for accumulator bleeddown instructions.
WA9719 Hydraulic Oil Level Check decal is located on
the hydraulic tank for models that include the combi-
nation oil level/thermometer sight glass.
Models which incorporate the two (2) "bubble" sight
gauges will have WB2471 Hydraulic Oil Level Check
decal located on the hydraulic tank.
NOTE: The information given on these decals pro-
vides the proper method of filling the hydraulic
tank. If the steps are not followed closely, possible
damage to hydraulic components may occur or
possible injury to the person servicing the truck.
Safety - Section 2
Page 2-9
Advertisement
Table of Contents
