Table of Contents
Advertisement
4
Ba sic Connections
It's essential that your video recorder be properly connected.
Follow these steps carefully. THESE STEPS MUST BE COM-
PLETED BEFORE ANY VIDEO OPERATION CAN BE PER-
FORMED.
CHECK CO N TEN TS
1
Make sure the package contains all of the accessories
listed in " Specifications" (
SITUATE RECO RDER
2
Place the recorder on a stable, horizontal surface.
CO N N ECT RECO RDER TO
TV
3
The connection method you use depends on the type of
TV you have.
RF CO N N ECTIO N
● To Connect To A TV With NO AV Input Terminals . . .
a– Disconnect the TV aerial cable from the TV.
b– Connect the TV aerial cable to the ANT. IN jack
on the rear panel of the recorder.
c– Connect the provided RF cable between the RF
OUT jack on the rear panel of the recorder and the
TV's aerial terminal.
Before operating the recorder, make sure the TV's preset
is set to the VIDEO preset.
AV CO N N ECTIO N
● To Connect To A TV With AV Input Terminals . . .
a– Connect the aerial, recorder and TV as per " RF
CONNECTION" .
b– Connect the provided SCART cable between the
AV1 IN/OUT socket on the rear panel of the
recorder and the TV's 21-pin SCART connector.
c– Set the RF OUT switch to OFF.
Before operating the recorder, make sure the TV is set to
the VIDEO (or AV) mode.
Downloaded from:
https://www.usersmanualguide.com/
Aerial terminal
21-pin SCART connector
pg. 55).
IN STALLIN G YO U R N EW RECO RD ER
Back of TV
CO N N ECT RECO RDER TO
MAIN S
4
Plug the end of the mains power cord into a mains
outlet.
RF Cable (provided)
21-pin SCART Cable
(provided)
Mains Power
Cord
Mains outlet
Advertisement
Table of Contents
