JVC HR-S9600EK Instructions Manual page 50

50
1
2
1
2
REW
STO P
Reta k e
You can cut out unnecessary parts of a TV programme while
you're recording it.
End of programme
Programme
EN GAGE RECO RD-P AUSE
MO DE
1
Press PAU SE during recording.
LO CATE ST ART PO IN T
2
Turn the JO G dial to the left or right (or hold down
REW or FF ) and release it when you reach the point
where you want to resume recording.
* Your recorder returns to the Record-Pause mode.
RESUME RECO RDIN G
3
Press PLAY when you wish to resume recording.
N O TE:
Retake function does not work during Direct Rec (
Downloaded from: https://www.usersmanualguide.com/
– –:– –
1 2 3
4 5 6
7 8 9
3
4
0
4
3
Beginning of programme
Unnecessary Unnecessary
Programme
part part
Recorded part
Go back to end of programme to cut out
unnecessary part
AD VAN CED O PERATIO N S (cont.)
Repea t Pla yba ck
Your video recorder can automatically play back the whole tape
50 times repeatedly.
ST ART PLAYBACK
1
Press PLAY .
ACTIVATE REPEAT PLAYBACK
2
Press PLAY and hold for over 5 seconds, then release.
● The Play indicator ( ) on the display panel blinks
● The tape plays 50 times automatically, and then stops.
STO P PLAYBACK
3
Press STO P at any time to stop playback.
FF
PAU SE
N O TE:
Pressing PLAY , REW , FF or PAU SE also stops Repeat Playback.
N TSC Pla yba ck
Your video recorder is equipped with NTSC circuitry that can
play back NTSC tapes.
LO AD A CASSETTE
1
Insert a cassette recorded in NTSC.
ST ART PLAYBACK
2
Press PLAY .
● "NTSC → PAL" appears on the screen for about 5
● Some TVs shrink the picture vertically and place
● The picture may roll up and down. This can be
● The counter and tape remaining time readings will be
● During search, still, or frame-by-frame playback, the
● Depending on the type of TV, the top and bottom
pg. 11).
slowly.
seconds.
black bars at the top and bottom of the screen. This is
not a malfunction on the part of either the video
recorder or the TV.
corrected using the V-HOLD control found on some
TVs. (This cannot be corrected if the TV does not
have a V-HOLD control.)
incorrect.
picture will be distorted, and there may be a loss of
colour.
portions of superimposed displays may be cut off
during NTSC playback.