Controller Settings; Enable Cloud-Based Controller Management - TP-Link Omada EAP230-Wall User Manual

5.2 Controller Settings

To make your controller adopt your EAP, make sure the EAP can be discovered by the
controller. Controller Settings enable your EAP to be discovered in either of the following
scenarios.
• If you are using Omada Cloud-Based Controller,
Management
• If your EAP and controller are located in the same network, LAN and VLAN, the controller
can discover and adopt the EAP without any controller settings. Otherwise, you need to
inform the EAP of the controller's URL/IP address, and one possible way is to
Controller Inform URL
For details about the whole procedure, refer to the User Guide of Omada SDN
Controller. The guide can be found on the download center of our official website:
https://www.tp-link.com/support/download/

Enable Cloud-Based Controller Management

Go to the System > Controller Settings page. In the Cloud- Based Controller Management
section, enable Cloud-Based Controller Management and click Save. After you add the
.
.
Enable Cloud-Based Controller
92
Configure