TP-Link Omada EAP230-Wall User Manual page 30

protection for wireless networks. Since WPA-Personal and WPA-Enterprise are much
safer than WEP, we recommend that you choose WPA-Personal or WPA-Enterprise if your
clients also support them.

Note:
WEP is not supported in 802.11n mode or 802.11ac mode. If WEP is applied in 802.11n, 802.11 ac
or 802.11n/ac mixed mode, the clients may not be able to access the wireless network. If WEP is
applied in 802.11b/g/n mode (2.4GHz) or 802.11a/n (5GHz), the EAP may work at a low transmission
rate.
The following table detailedly introduces how to configure each item:
Type
Key Selected
WEP Key Format
Key Type
Select the authentication type for WEP.
Auto: The EAP can select Open System or Shared Key automatically based
on the wireless capability and request of the clients.
Open System: Clients can pass the authentication and associate with
the wireless network without password. However, correct password is
necessary for data transmission.
Shared Key: Clients have to input the correct password to pass the
authentication, otherwise the clients cannot associate with the wireless
network or transmit data.
Select one key to specify. You can configure four keys at most.
Select ASCII or Hexadecimal as the WEP key format.
ASCII: With this format selected, the WEP key can be any combination of
keyboard characters of the specified length.
Hexadecimal: With this format selected, the WEP key can be any
combination of hexadecimal digits (0-9, a-f, A-F) with the specified length.
Select the WEP key length for encryption.
64Bit: Enter 10 hexadecimal digits or 5 ASCII characters.
128Bit: Enter 26 hexadecimal digits or 13 ASCII characters.
152Bit: Enter 32 hexadecimal digits or 16 ASCII characters.
26