TP-Link Omada EAP230-Wall Quick Installation Manual

Quick Installation Guide
Wireless Wall Plate Access Point
Setup with videos
Scan QR code or visit
https://www.tp-link.com/support/setup-video/
Note: The image may differ from the actual product.
Hardware Overview
1
Front Panel
LED
LED/Wi-Fi Button
When the EAP is working in Standalone Mode and enabled with Wi-Fi
Control, press the button to turn on/off both the Wi-Fi and LED. In the other
cases, press the button to turn on/off the LED only.
LAN Port
A wired device can be connected to the LAN port via an Ethernet cable and
access the network.
RESET
With the EAP powered on, press and hold the button for about 5 seconds
until the LED flashes, then release the button. The EAP will restore to factory
default settings.
LED Indicator
On: Working normally/Initializing.
Off: Working abnormally/Power off/LED is turned off.
Flashing:
Initialization: The LED flashes twice after initialization is completed.
Upgrade: The LED flashes once per second while upgrading.
Reset: The LED flashes quickly during the reset. The EAP will then reboot.
Locate: When the Locate feature is activated in the Omada controller, the
LED flashes quickly to locate and identify the device. The LED will flash for
10 minutes, or you can disable the feature manually to stop it flashing.
Rear Panel
UPLINK+PoE Port
Connected to a PSE (Power Sourcing Equipment), such as a PoE switch, for
both data transmission and Power.
2 Pre-Installation Checklist
Before installation, be sure that you have the following items:
A pre-installed wall junction box
An RJ45 plug
A triangular screwdriver
Installation Steps
LED/Wi-Fi Button 3
LAN Port
The EAP can be mounted into either an 86 mm wall junction box or a standard EU
RESET wall junction box. The junction box should be pre-installed with a running-in-wall
Ethernet cable connected to a PoE switch.
86 mm wall junction box
1. Detach the faceplate of the junction box with a Phillips screwdriver
(demonstrated with an 86 mm wall junction box).
2. Detach the faceplate of the EAP with a screwdriver.
3. Connect the Ethernet cable inside the junction box to an RJ45 plug. Then
connect the cable to the UPLINK+PoE port. Position the Ethernet cable
to ensure it is not strained.
A Phillips screwdriver
A PoE switch
4. Insert the enclosed screws and tighten them with a triangular screwdriver
to secure the mounting bracket.
Standard EU wall junction box
5. Press the faceplate of the EAP back into position.
Note:
Do not over tighten the screws.
If the enclosed screws do not fit the junction box, use the screws attached to the
junction box instead.