Troubleshooting - JVC GR-DVL515 Instructions Manual

72
EN
If, after following the steps in the chart below, the problem still exists, please consult your nearest JVC dealer.
The camcorder is a microcomputer-controlled device. External noise and interference (from a TV, a radio,
etc.) might prevent it from functioning properly. In such cases, first disconnect its power supply unit (battery
pack, AC Adapter, etc.) and wait a few minutes; and then re-connect it and proceed as usual from the
beginning.
SYMPTOM
1. No power is supplied.
2. "SET DATE/TIME!" appears.
3. Recording cannot be
performed.
4. There is no picture.
5. The focus does not adjust
automatically.
6. The cassette will not load
properly.
7. The memory card will not
load properly.
8. Snapshot mode cannot be
used.
Downloaded from:
1. • The power is not connected
• The battery is dead.
2. • The date/time is not set.
• The built-in clock battery has
3. — For Video Recording —
• The tape's erase protection tab
• The Power Switch is set to
• The VIDEO/DSC Switch is set
• "TAPE END" appears.
• The cassette holder cover is
— For D.S.C. Recording —
• The VIDEO/DSC Switch is set
4. • The camcorder is not getting
5. • Focus is set to the Manual
• The recording was done in a
• The lens is dirty or covered
6. • The cassette is in the wrong
• The battery's charge is low.
7. • The memory card is in the
8. • The Squeeze mode is
https://www.usersmanualguide.com/
POSSIBLE CAUSES
properly.
run out and the previously set
date/time has been erased.
is set to "SAVE".
" " or "OFF".
to " ".
open.
to "VIDEO".
power, or some other
malfunction exists.
mode.
dark place, or the contrast
was low.
with condensation.
position.
wrong position.
selected.

TROUBLESHOOTING

CORRECTIVE ACTION
1. • Connect the AC Adapter
securely (
• Replace the dead battery with
a fully charged one
( pg. 8, 9).
2. • Set the date/time (
• Consult your nearest JVC
dealer for replacement.
3. • Set the tape's erase protection
tab to "REC" (
• Set the Power Switch to "
or " " (
• Set the VIDEO/DSC Switch to
"VIDEO".
• Replace with new cassette
( pg. 12).
• Close the cassette holder
cover.
• Set the VIDEO/DSC Switch to
" ".
4. • Turn the camcorder's power
off and on again (
5. • Set Focus to the Auto mode
( pg. 43).
• Clean the lens and check the
focus again (
6. • Set it in the right position
( pg. 12).
• Install a fully charged battery
( pg. 8, 9).
7. • Set it in the right position
( pg. 14).
8. • Disengage the Squeeze mode
( pg. 48).
pg. 9).
pg. 11).
pg. 12).
"
pg. 17).
pg. 17).
pg. 77).