Troubleshooting - JVC GR-DV L155 Instructions Manual

TROUBLESHOOTING

If, after following the steps in the chart below, the problem still exists, please consult your nearest JVC dealer.
The camcorder is a microcomputer-controlled device. External noise and interference (from a TV, a radio,
etc.) might prevent it from functioning properly. In such cases, first disconnect its power supply unit (battery
pack, AC Adapter, etc.) and wait a few minutes; and then re-connect it and proceed as usual from the
beginning.
SYMPTOM
1
No power is supplied.
2
"SET DATE/TIME!"
appears.
3
Recording cannot be
performed.
4
There is no picture.
5
The focus does not adjust
automatically.
6
The cassette will not load
properly.
7
Snapshot mode cannot be
used.
8
The colour of Snapshot
looks strange.
Downloaded from:
POSSIBLE CAUSES
• The power is not connected
properly.
• The battery is dead.
• The date/time is not set.
• The built-in clock battery has run
out and the previously set date/time
has been erased.
• The tape's erase protection tab is
set to "SAVE".
• The Power Switch is set to "PLAY"
or "OFF".
• "TAPE END" appears.
• The cassette holder cover is open.
• The camcorder is not getting
power, or some other malfunction
exists.
• Focus is set to the Manual mode.
• The recording was done in a dark
place, or the contrast was low.
• The lens is dirty or covered with
condensation.
• The cassette is in the wrong
position.
• The battery's charge is low.
• The Squeeze mode is selected.
• The light source or the subject does
not include white. Or there are
various different light sources
behind the subject.
• The Sepia or Monotone mode is
activated.
https://www.usersmanualguide.com/
CORRECTIVE ACTION
• Connect the AC Adapter securely
( pg. 9).
• Replace the dead battery with a
fully charged one ( pg. 8, 9).
• Set the date/time ( pg. 11).
• Consult your nearest JVC dealer
for replacement.
• Set the tape's erase protection tab
to "REC" ( pg. 12).
• Set the Power Switch to "
" " ( pg. 16).
• Replace with new cassette
( pg. 12).
• Close the cassette holder cover.
• Turn the camcorder's power off
and on again ( pg. 16).
• Set Focus to the Auto mode
( pg. 29).
• Clean the lens and check the focus
again ( pg. 57).
• Set it in the right position
( pg. 12).
• Install a fully charged battery
( pg. 8, 9).
• Disengage the Squeeze mode
( pg. 34).
• Find a white subject and compose
your shot so that it also appears in
the frame ( pg. 28).
• Turn off Sepia and Monotone
( pg. 24, 25).
CONTINUED ON NEXT PAGE
53
EN
" or