Advertisement
ADDITIONAL FEATURES
Set new CSR default: Set a CSR in PCC with customer-selected settings. If settings are not
changed, the camera may be powered off and on and the CSR will remain active. Cameras
must be set in full resolution.
Programmable I/O: Assign and define signal parameters for each programmable I/O port.
Available signals include: Strobe, Ready, F-Sync, Pre-Trigger, Event, Memory Gate and
several core signals. See Programmable I/O section for more detail.
Data Acquisition: External sensor data imported through a compatible National Instruments
DAQ model can be embedded in Cine files sand visualized in PCC along with the high-speed
images.
Image-Based Auto-Trigger (IBAT): Trigger the camera (or a number of connected cameras)
from motion detected within the live image.
Exposure Tools: Auto-exposure, Threshold mode for the video output, PCC histogram, and
a Zebra pattern overlay in PCC are all tools used to dial in the best exposure without over
saturation.
Multi-Cine: Support for up to 63 partitions.
Quiet Fans: When enabled, the fans are stopped during capture to eliminate vibration.
Continuous Recording: Automatically and continuously saves Cines to external storage.
DHCP: Dynamic Host Configuration Protocol enables the automatic assignment of an IP
address when using a DHCP router. This method eliminates the requirement to define the
PC's dedicated camera network. Automatic DHCP is an alternative to the secondary user-
definable IP network available in all Phantom cameras.
HV Trigger: High Voltage (HV) trigger, when selected in PCC the camera will trigger from a
+6-32V pulse.
Detailed information about Phantom cameras, features, and software can be
found at: www.phantomhighspeed.com
Chapter 1: Introduction | 3
Advertisement
