Advertisement
The NetConfig Utility will show all network interfaces currently installed in the PC.
Identify the one that will be physically connected to the camera (this process can be done
with or without a camera connected at the time).
Click 'Config Adapter', which will then adjust the IP Address and Subnet to the first one
available within the 100.100 network that all Phantom cameras are pre-configured to
work with. Once connected, the Phantom logo will appear on the lower right with the
"Configured for PCC operation" message.
OPTIONAL: MANUALLY A SSIGN Gb CAMER A NE T W ORK
Alternatively, In the Windows 'Network and Sharing Center,' select the camera
network.
Change the Ethernet IP settings by selecting 'Properties,' then 'TCP/IPv4' 'Properties,'
then select 'Use the following IP address.'
Enter IP address 100.100.100.1 and Subnet 255.255.0.0. Other settings should be
blank.
POWER ON CAMERA
Connect the camera's dedicated power supply to the mini-XLR port. The camera is ready
for operation when the red capture light of the Trigger button is illuminated.
LAUNCH PCC SOFTWARE
Double-click the PCC icon located on the desktop. Camera will be recognized
immediately if connected and network settings are correct.
SELECT CAMERA FOR USE
In the 'Manager' tab, select the Phantom camera to be used from the 'Cameras' group
folder. Click the 'Live' tab.
DEFINE RECORDING PARAMETERS
Click 'Cine Settings' and define the following parameters by either selecting the value
from the pull-down selection list or typing a value into the respective data entry field.
1.
Set 'Resolution' to the required Width x Height.
2. Choose the required 'Sample Rate,' and 'Exposure Time'.
3. Set 'Post Trigger' to zero (0) by moving the 'T' (Trigger Position) slider to the right,
or enter zero (0) into the 'Last' data entry field.
Vision Research, Inc. | Miro C211 Camer a Manual
Advertisement
