Panasonic KX-TG5210M Operating Instructions Manual page 76

Troubleshooting
General
Problem
The handset and/or base unit
does not work.
"Recharge battery" is
displayed, "
3
or the handset beeps
intermittently.
"Charge for 6 HRS" and
" " are displayed and the
4
handset does not work.
You charged the battery fully,
but "Recharge battery" is
still displayed and/or "
continues to flash, or "Charge
for 6 HRS" and "
displayed.
The CHARGE indicator does
not go out after the battery has
been charged.
If you cannot solve your
problem
76
• Check the settings (p. 12–14).
• Check whether the dialing mode setting is
• Fully charge the battery (p. 13).
• Clean the charge contacts and charge again
• Check battery installation (p. 13).
• Unplug the base unit's AC adaptor to reset it.
• The handset has not been registered to the
• Re-install the battery (p. 13) and fully charge
• Fully charge the battery (p. 13).
" flashes,
• The battery has been discharged. Fully
• Clean the charge contacts and charge again
" • The battery may need to be replaced. If you
3
" are
4
• This is normal.
• Visit our website:
• Contact us via the web at:
• Call our customer call center at:
Cause & Remedy
correct (p. 18).
(p. 14).
Plug in, and try again.
base unit. Register the handset (p. 70, steps
5 and 6).
it.
charge the battery (p. 14).
(p. 14).
install a new battery, fully charge it (p. 13, 14).
http://www.panasonic.com/support
http://www.panasonic.com/contactinfo
1-800-211-PANA(7262)