Table of Contents
Advertisement
Troubleshooting
Cleaning the Paper Feed
Roller
If the paper feed roller is dirty, a mis-
feed might occur. In this case, clean
the roller as follows:
R CAUTION:
• When lifting the printer, use the
grips on both sides of the printer,
otherwise the printer might fall
and cause personal injury.
• When you move the printer, un-
plug the power cord from the wall
outlet to avoid a fire or an electric
shock.
5
• When you pull out the plug from
the socket, grip the plug to avoid
damaging the cord and causing
a fire or an electric shock.
Important
❒ The following are examples of
cleaning the paper feed roller on
the paper tray.
❒ You can clean the paper feed roller
on the optional Paper Feed Unit by
following the procedures below.
The paper feed roller on the op-
tional Paper Feed Unit differs from
the one on the paper tray. Confirm
the type of paper feed roller you
are installing.
For the paper tray
A A A A
Turn off the power switch.
B B B B
Pull out the plug from the socket.
Remove all the cables from the
printer.
94
For the Paper Feed Unit
ZCEM200E
C C C C
Lift the paper tray slightly then
pull it out until it stops, and while
lifting the front side of the tray,
pull it out of the printer.
D D D D
Move the printer to the edge of a
stable table or desk.
Important
❒ Do not put the printer on an un-
stable or tilted surface.
❒ If the printer is equipped with
the optional Paper Feed Unit,
do not move the printer and
unit together as they are not se-
curely attached.
❒ When lifting the printer, con-
firm that the optional Paper
Feed Unit is not attached to the
printer.
ZCEY140J
ZGDM110J
Advertisement
Table of Contents
