Cleaning And Adjusting The Printer; Cleaning The Friction Pad - Ricoh LANIER AP2610 Operator's Manual

Cleaning and Adjusting the Printer

Cleaning the Friction Pad

If the friction pad is dirty, a multi-
feed or a misfeed might occur. In this
case, clean the pad as follows:
A A A A
Lift the paper tray slightly then
pull it out until it stops, and while
lifting the front side of the tray,
pull it out of the printer.
B B B B
Place the tray on a flat surface.
When there is paper in the tray,
remove paper.
C C C C
Wipe the brown part of the fric-
tion pad with a soft damp cloth.
After that, wipe it with a dry cloth
to remove the water.
Important
❒ Do not use chemical cleaner or
organic solvent such as thinner
or benzene.
D D D D
Load paper into the paper tray
with the print side up. Carefully
slide the paper tray into the print-
er until it stops.
Important
❒ Do not slide the paper tray in
with force. If you do, the front
and side guides might move.
ZCEY140J
Note
❒ If misfeeds or multi-feeds of pa-
per occur after cleaning the fric-
tion pad, contact your sales or
service representative.
❒ Follow the same procedure to
clean the friction pad of the op-
tional Paper Feed Unit and the
Envelope Feeder Unit.
TS3Y250E
Cleaning and Adjusting the Printer
5
ZCEY150J
93