Ricoh LANIER AP2610 Operator's Manual page 129

E E E E
Press { { { { Enter #} } } } .
One of the following messages appears on the panel display.
WL.LAN Signal
Good
WL.LAN Signal
Fair
WL.LAN Signal
Poor
WL.LAN Signal
Unavailable
Note
❒ If "WL.LAN Signal" is not displayed, "IEEE 802.11b" has not been selected
for "LAN Type" in "Network Setup" of the Host Interface menu. Select
"IEEE 802.11b" for "LAN Type", and then check the "WL.LAN Signal" in
the Maintenance menu again.
❒ If "Ad hoc" in "Comm. Mode" of "IEEE 802.11b" in the Host Interface menu
is selected, you cannot check the signal. Select "Infrastructure" and then
check it again.
❒ Every time you press { { { { Enter #} } } } , the signal is updated.
❒ The signal is indicated as "Good" if the signal strength is 76-100%, "Fair" if
the strength is 41-75%, "Poor" if the strength is 21-40%, and "Unavailable"
if the strength is 0-20%. If the signal is unstable or unavailable, remove ob-
stacles or move the printer to a place where the signal can be received.
❒ Using wireless devices or microwave sources near the printer might affect
the signal.
F F F F
Press { { { { Escape} } } } .
100%
50%
30%
18%
Maintenance Menu
121
6