Supermicro X11SDV-8C+-TLN2F User Manual page 44

Super X11SDV-4C/8C/8C+/12C/16C/16C+-TLN2F User's Manual
OCulink Interface Selection
Use the JNS1 jumper to set the OCulink port to either function as four SATA ports or a single
PCIe x4 NVMe interface.
Watch Dog
JWD1 controls the Watch Dog function. Watch Dog is a monitor that can reboot the system
when a software application hangs. Jumping pins 1-2 will cause Watch Dog to reset the system
if an application hangs. Jumping pins 2-3 will generate a non-maskable interrupt signal for
the application that hangs. Watch Dog must also be enabled in BIOS.
Note: When Watch Dog is enabled, users need to write their own application software
to disable it.
LED3 VGA
Aspeed
AST2500
JTPM1
S-SATA0
2
X11SDV-4C-TLN2F
REV: 1.02
DESIGNED IN USA
1
DIMME1 DIMMD1
OCulink Interface Selection
Jumper Settings
Jumper Setting
Pins 1-2
Pins 2-3
Watch Dog
Jumper Settings
Jumper Setting
Pins 1-2
Pins 2-3
Open
JIPMB1
Intel
X557-AT2
LAN1/LAN2
CPU
JF1
PWR OH HDD PWR
RST X NIC2 NIC1
ON FF LED LED
BT1
JBT1
DIMMA1
Definition
4x SATA
PCIe x4 (Default)
Definition
Reset (Default)
NMI
Disabled
1. OCulink Interface Selection
2. Watch Dog Timer
IPMI_LAN
USB 2/3(3.0)
USB0/1
JF1
LED1
PJ1
DIMMB1
44