Table of Contents
Advertisement
EN
be at the minimum safety distance from the heater
and at a maximum height of one metre from the
floor. Figure 4.
Conductor tubing (ø 30 mm) inside the wall struc-
ture allows you to thread the data cable hidden
within the wall – otherwise the installation will have
to be on the wall surface. We recommend you to
install the control panel embedded in to the wall and
far away from possible splashes.
3.2. installing the Power Unit
Install the power unit to a wall outside the sauna
room, in a dry place with an ambient temperature
of >0 ºC. See figure 5 for instructions on how to
open the power unit cover and how to fix the unit
to the wall.
Note! Do not embed the power unit into the wall,
since this may cause excessive heating of the in-
ternal components of the unit and lead to damage.
See figure 5.
Figure 5.
Opening the power unit cover and mounting the unit to a wall
图5
电源控制装置面盖打开方法及正确安装位置
3.2.1. Electrical Connections
Figure 6 shows the electrical connections of
the power unit. For more detailed installation
instructions see the instructions for installation and
use of the selected heater model.
3.2.2. Power Unit Fuse Faults
Replace a blown fuse by a new one with the same
value. The placement of the fuses in the power unit
is shown in figure 6.
If the fuse for the electronic card has blown,
•
there is likely a fault in the power unit. Service
is required.
If the fuse in the line U2 has blown, there
•
is a problem with lighting. Check the
wiring and functioning of lighting and fan.
10
中
如果面板安装在桑拿房，它必须安装在离开桑拿
炉的最小安全距离，并离地面不高于一米高度。
图4。
您可以用导线管（直径30mm）把数据线隐藏在
墙壁内部，否则,数据线将会顕在墙面上。我们建
议控制面板安嵌入墙体，远离可能溅起的水花
3.2. 电源控制装置
电源控制装置要安装在干燥的桑拿房间外， 周围
环境的温度要大于>0 ºC
电源控制装置安装及面盖打开方法见 图5.
注意! 电源控制装置不能藏于墙内安装。电源
控制装置内热力如不能散发会导致事故发生，
正确位置请参见 图5。
3.2.1. 电源接线
电源连接必须按照国家法规，并且由合格之电工
安装。图6.电源线必须符合国家后与安全标准。
可参考桑拿炉附带的说明书获得更多电源连接资
料。
3.2.2. 保险丝故障
保险丝烧断后，请在排除问题后更换同一型号之保险
丝。图6.
如果电路板保险丝为已熔断，有可能是电源控制装
•
置故障。必需要维修服务。
如果U2保险丝已熔断，表示选配安装的照明灯设备
•
有问题。请检查照明和风扇的线路和运作。
Advertisement
Table of Contents
