Table of Contents
Advertisement
UG-182
2
USING I
C SERIAL PORT MODE
2
Figure 3. I
C Address Jumper Setting
To use the I2C serial Port mode, follow these steps:
1.
Power down the board and shut down the software.
2.
Set Jumpers P11 and P13 to the I2C position (see Figure 2).
3.
Select the desired I
(see Figure 3). Note that setting P5 and P6 low is reserved
for SPI mode.
4.
Power up the board and connect the USB cable to the board.
5.
Start the evaluation board software.
6.
On the evaluation software, select Configure Serial Port
from the I/O menu (see the I/O Menu section).
7.
Click the Reset Serial Port button, and then click Detect
Current Configuration (see Figure 8). A dialog box
should appear to acknowledge the I
Rev. 0 | Page 4 of 16
Evaluation Board User Guide
2
C address using Jumpers P5 and P6
2
C mode and address.
Advertisement
Table of Contents
