Remove The Server From The Rack - HP ProLiant ML30 Gen10 User Manual

Remove the server from the rack

Remove the server from the rack
WARNING: This server is heavy. To reduce the risk of personal injury or damage to the WARNING:
equipment:
Observe local occupational health and safety requirements and guidelines for manual
material handling.
Get help to lift and stabilize the product during installation or removal, especially when the
product is not fastened to the rails. Hewlett Packard Enterprise recommends that a
minimum of two people are required for all rack server installations. A third person may be
required to help align the server if the server is installed higher than chest level.
Use caution when installing the server in or removing the server from the rack; it is unstable
when not fastened to the rails.
Procedure Procedure
1. Power down the server.
2. Remove all power:
a. Disconnect each power cord from the power source.
b. Disconnect each power cord from the server.
3. Disconnect all peripheral cables from the server.
4. If installed, unlock and remove the security padlock and/or the Kensington security lock.
For more information, see the lock documentation.
5. Extend the server from the rack .
6. Remove the server from the tray.
7. Place the server on a flat, level surface with the access panel facing up.
Remove the server from the rack 33