HP ProLiant ML30 Gen10 User Manual page 122

11. If removed, install the air baffle .
12. Install the access panel .
13. Install the front bezel .
14. Do one of the following:
If the server is in tower mode: Position the tower server for operation .
If the server is in rack mode: Install the server on the tray .
15. Connect all peripheral cables to the server.
16. Connect the power cords:
a. Connect each power cord to the server.
b. Connect each power cord to the power source.
17. Power up the server .
The installation is complete.
To configure the M.2 SSD, see the HPE Smart Array SR Gen10 Configuration Guide at the Hewlett Packard Enterprise website
Installing an M.2 NVMe SSD on an M.2 SSD/dedicated iLO/serial port enablement board
Hewlett Packard Enterprise website .
122