Enabling The Dedicated Ilo Management Module - HP ProLiant ML30 Gen10 User Manual

Enabling the dedicated iLO management module

Enabling the dedicated iLO management module
The onboard NIC 1/shared iLO connector is set as the default system iLO connector. To enable the dedicated iLO management module,
use the iLO 5 Configuration Utility accessible within the HPE UEFI System Utilities.
For more information on the UEFI System Utilities, see the UEFI documentation on the Hewlett Packard Enterprise website (
https://www.hpe.com/servers/uefi). https://www.hpe.com/servers/uefi
IMPORTANT: IMPORTANT:
If the iLO configuration settings are reset to the default values, remote access to the machine will be lost. Access the
physical machine and repeat the procedure described in this section to re-enable the dedicated iLO management
connector.
Procedure Procedure
1. During the server startup sequence after installing the module, press F9 in the POST screen.
The System Utilities screen appears.
2. Select System Configuration | iLO 5 Configuration Utility.
The iLO 5 Configuration Utility screen appears.
3. Select Network Options, and then press Enter.
The Network Options screen appears.
4. Set the Network Interface Adapter field to ON, and then press Enter.
5. Press F10 to save your changes.
A message prompt to confirm that the iLO settings reset appears.
6. Press Enter to reboot the iLO settings.
7. Press Esc until the main menu is displayed.
8. Select Reboot the System to exit the utility and resume the boot process.
The IP address of the enabled dedicated iLO connector appears on the POST screen on the subsequent boot-up. Access the Network
Options screen again to view this IP address for later reference.
Enabling the dedicated iLO management module 116