Table of Contents
Advertisement
13. Connect the drive cables .
14. If removed, install the air baffle .
15. Install the access panel .
16. Install the front bezel .
17. Do one of the following:
If the server is in tower mode: Position the tower server for operation .
If the server is in rack mode: Install the server on the tray .
18. Connect all peripheral cables to the server.
19. Connect the power cords:
a. Connect each power cord to the server.
b. Connect each power cord to the power source.
20. Power up the server .
The installation is complete.
To configure arrays, see the HPE Smart Array SR Gen10 Configuration Guide at the Hewlett Packard Enterprise website
Hewlett Packard Enterprise website .
Installing an LFF non-hot-plug drive in the media drive bay
102
Advertisement
Table of Contents
Troubleshooting
