HP ProLiant ML30 Gen10 User Manual page 115

12. Connect the serial port cable to the M.2 SSD/dedicated iLO/serial port enablement board .
To prevent the serial port cable from blocking the system fan airflow, route the cable beneath the fan, and then secure the extra
length of the cable in the serial port cable clip.
13. If removed, install the air baffle .
14. Install the access panel .
15. Install the front bezel .
16. Do one of the following:
If the server is in tower mode: Position the tower server for operation .
If the server is in rack mode: Install the server on the tray .
17. Connect all peripheral cables to the server.
18. Connect the power cords:
a. Connect each power cord to the server.
b. Connect each power cord to the power source.
19. Power up the server .
The installation is complete.
Installing the serial port cable 115