Using The Unit - Beverage-Air FB Series Installation And Operating Instructions Manual

User Manual for FB Freezers

USING THE UNIT

Operation is simple, just keep it connected to the correct
power supply and the refrigerator will maintain the
internal temperature it has been set to. Keep the doors
and / or drawers closed as much as possible to avoid
unnecessary run time.
The controller displays the current internal temperature.
Adjusting the set temperature lower will NOT cause the
system to lower the temperature faster. When on, the
refrigeration system is always operating at maximum.
For best results, make certain the unit remains powered
and has achieved the desired set point before loading
it with product. Pull down time will vary depending
upon the type of unit and ambient conditions. Freshly
cooked product, or otherwise warm product placed
into the appliance will also increase the pull down time
significantly since this model is designed for storage and
not for rapid pull down.
Defrost
Select
In most cases the only thing displayed will be the cabinet temperature. When something other than normal operation has
occurred, a message will be shown.
Message Displayed
dEF
Hi
dOr
LEA
E01, E02, E03, E04
12
The temperature was set at the factory at 0
adjust it to your own selected temperature. 30 seconds
after adjustment, the display automatically reverts to
showing the current temperature.
The freezer will automatically defrost as needed, there is
no set time for defrost. Push and immediately release the
"melting" or defrost button for a manual defrost.
Note: Holding the defrost button in too long will shut the
controller off.
The internal fan will be on when the compressor is on and
when the doors are closed.
The compressor and condenser fan motor will only be on
when the controller senses an increase in internal cabinet
temperature passed the set point.
If equipped with glass doors, holding the SC button in will
turn the cabinet light on or off.
0
Why
Unit is defrosting
Cabinet temperature too warm
Door is open
Compressor run time too long
Sensor unplugged or has failed
Beverage-Air
Beverage-Air
F
o
What to do
Nothing. Normal operation.
Confirm doors or drawers are closed.
Close door, if message does not
change, call for service.
Check doors closed. If yes, call for
service.
Call for service.
F, but you can
º
Increase
Decrease
Rev. 07/22