Advertisement
M M O O N N I I T T O O R R I I N N G G S S Y Y S S T T E E M M
The engine monitoring system provides engine operating information and alerts
you of abnormal conditions that could damage your outboard. The monitoring
system consists of a dashmounted display or gauge, sensors on the engine and
oil tank, and other components of the electrical system.
When a fault occurs, this system sends visual messages through the Multifunc-
tion Display (MFD) to inform you of a particular condition. A fault code may also
be recorded.
When a minor or transient fault occurs, the fault message will cease automati-
cally if the condition that caused it no longer exists.
Returning the control lever to the neutral position and letting the engine return to
idle speed may allow normal operation to return.
The monitoring system will react differently depending on the fault type. In severe
failure, the engine may not be allowed to be started. In other cases, the engine
will operate in S.A.F.E. mode (reduced speed).
When a fault occurs, please refer to the INDICATORS AND MESSAGE DIS-
PLAY INFORMATION section for information.
F F a a u u l l t t C C o o d d e e s s
When a fault occurs, a numerical fault code may be recorded, depending on the
fault type and system.
These fault codes can be used by an authorized BRP dealer to troubleshooting
the boat systems when comparing them to a fault list.
Fault codes can be viewed by the operator using the MFD; however, this function
is only available while the fault is active.
The operator may then choose to call their authorized BRP dealer to pass on the
fault code. The dealer will then advise the operator on the steps to take to solve
the problem, or to stop using the boat and to bring it in to the dealer for repairs.
78
Advertisement
