Advertisement
MAINTENANCE PROCEDURES
2. Wedge a block of wood between
the propeller blade and the anti--
ventilation plate.
3. Remove the slotted nut, and then
remove the block of wood.
4. Remove the spacer.
5. Remove the propeller.
6. Remove the thrust bushing.
1. Slotted nut
2. Spacer
3. Propeller
4. Thrust bushing
I I n n s s t t a a l l l l i i n n g g t t h h e e P P r r o o p p e e l l l l e e r r
W W A A R R N N I I N N G G
W W h h e e n n s s e e r r v v i i c c i i n n g g t t h h e e p p r r o o p p e e l l l l e e r r , , a a l l - -
w w a a y y s s s s h h i i f f t t t t h h e e o o u u t t b b o o a a r r d d t t o o t t h h e e
N N E E U U T T R R A A L L p p o o s s i i t t i i o o n n , , t t u u r r n n t t h h e e k k e e y y
s s w w i i t t c c h h O O F F F F , , a a n n d d r r e e m m o o v v e e t t h h e e k k e e y y
s s o o t t h h e e o o u u t t b b o o a a r r d d c c a a n n n n o o t t b b e e s s t t a a r r t t e e d d
a a c c c c i i d d e e n n t t a a l l l l y y . .
I I M M P P O O R R T T A A N N T T
board engines REQUIRE propeller
hardware kit, P/N 5012290. This kit
can be ordered from an authorized
BRP dealer.
52
: Rotax E-TEC out-
1. Apply Triple Guard grease to the
entire propeller shaft before instal-
ling the propeller.
R R e e q q u u i i r r e e d d P P r r o o d d u u c c t t
T T r r i i p p l l e e G G u u a a r r d d g g r r e e a a s s e e
P P / / N N 5 5 0 0 8 8 2 2 9 9 8 8
2. Install the thrust bushing so that
the taper of the bushing matches
the taper of the shaft.
3. Align the splines of the propeller
with the splines of the propeller
shaft. Push the propeller until it is
seated on the thrust bushing.
4. Install the spacer.
1. Slotted nut
2. Spacer
3. Propeller
4. Thrust bushing
5. Wedge a block of wood between
the propeller blade and the anti--
ventilation plate.
6. Tighten the slotted nut to a torque
of 120 to 144 in·lb (13.6 to 16.3
Advertisement
