Advertisement
G G E E A A R R C C A A S S E E V V E E N N T T
1. Vent plug
4. Place a container under the drain.
E E N N V V I I R R O O N N M M E E N N T T A A L L N N O O T T E E
Dispose of used oil or oil contami-
nated shop towels in an environmen-
tally responsible manner, or
according to local regulations.
5. Open the gearcase drain plug.
G G E E A A R R C C A A S S E E D D R R A A I I N N
1. Drain plug
I I M M P P O O R R T T A A N N T T
gear lubricant is formulated for marine
applications. Do not use automotive
gear lubricants, engine oils, or any
other oil or grease.
6. Use Gearcase Filler, P/N 501882,
to slowly fill the gearcase with HPF
Pro lubricant until lubricant exits
the gearcase vent.
: The recommended
MAINTENANCE PROCEDURES
I I M M P P O O R R T T A A N N T T
case too quickly can cause air pockets
and
the
gearcase
completely.
7. Wait 5 minutes for the oil to settle.
8. Continue filling again until oil exits
the vent. For recommended gear-
case lubricant capacity, refer to
TECHNICAL SPECIFICATIONS .
9. Clean vent seal area and install
the gearcase vent plug and a n n e e w w
seal. Tighten the plug to a torque
of 60 to 84 in. lbs. (7 to 9.5 N·m).
10. Clean drain seal area and install
the lubricant drain/fill plug and a
n n e e w w seal. Tighten the plug to a tor-
que of 60 to 84 in. lbs. (7 to 9.5
N·m).
P P r r o o p p e e l l l l e e r r
P P r r o o p p e e l l l l e e r r R R e e m m o o v v a a l l
W W A A R R N N I I N N G G
W W h h e e n n s s e e r r v v i i c c i i n n g g t t h h e e p p r r o o p p e e l l l l e e r r , , a a l l - -
w w a a y y s s s s h h i i f f t t t t h h e e o o u u t t b b o o a a r r d d t t o o t t h h e e
N N E E U U T T R R A A L L p p o o s s i i t t i i o o n n , , t t u u r r n n t t h h e e k k e e y y
s s w w i i t t c c h h O O F F F F , , a a n n d d r r e e m m o o v v e e t t h h e e k k e e y y
s s o o t t h h e e o o u u t t b b o o a a r r d d c c a a n n n n o o t t b b e e s s t t a a r r t t e e d d
a a c c c c i i d d e e n n t t a a l l l l y y . .
1. Remove the cotter pin from the
propeller shaft. Discard the cotter
pin.
1. Cotter pin
:
Filling the gear-
may
not
fill
51
Advertisement
