Table of Contents
Advertisement
8/11/22, 2:30 PM
Setting Up a Build to Print
NOTE: Before starting your rst part, please ensure that the printer is clean and that it
is kept well-maintained. Please see the ProJet CJP X60 Series User Guide for further
instructions on properly cleaning your printer.
1. Open your 3D content in 3DPrint.
2. Under
Settings
3. Check your printer settings to be sure the
correct printer and material set are
displayed.
NOTE: If you need to change any
settings, refer to the Setup and
Print the Build section of the User
Guide
4. In
Home
tab, press "Build" icon.
5. Check the Printer Status window. If all
the
Print
Head, Core™, and
display OK, the
NOTE: If any items need attention,
the Print button is disabled. Refer
to the Additional Operations
section of the User Guide for
details on how to get the printer
ready and clear any messages.
infocenter.3dsystems.com/projetcjpx60/print/book/export/html/861
tab, press "Materials."
General
items
Print
button is enabled.
Quick Start Guide
®
. Select any Print Options for this build. If
the part has delicate features, deselect
the option for
(ProJet 460 Plus only).
Printing
7. Click
Print
. The
Printing
status of the print job as the build
progresses.
9. Click
Pause
job. Click again to resume printing.
10. Click
Cancel
Important: Pausing for more than 10
minutes may cause print defects.
Empty Build Piston After
to start your build.
dialog opens and reports the
to pause the current print
to cancel printing this job.
9/14
Advertisement
Table of Contents
