ProJet 60 Series Quick Start Manual page 13

8/11/22, 2:30 PM
Pull the Fast Axis toward the front of the printer.
Using a paper towel dampened with distilled water, wipe the top and bottom Rails. Move the
Carriage back and forth as needed to clean the entire length of both rails. Using a clean, dry
paper towel, thoroughly dry both Rails.
Using a fresh paper towel, wipe the Carriage to remove any Core. Clean the Build Bed and Deck of
any water or damp Core.
Clean the Service Station
You will need several dry paper towels and a cotton swab, a squirt bottle lled with distilled water,
disposable gloves, and Pick and Syringe from the Accessories Kit.
Open the printer top cover and the Service Station cover.
Place paper towels around the Service Station as well as the Front Over ow and the Build Bed.
Pull the Service Station wiper lever all the way forward until the rubber squeegees are fully
exposed. Use caution - Binder may ing off of the
and around the squeegees.
Pay special attention to the underside of the squeegee scraper bar. Ensure it is fully cleaned.
Important:
Wipe the front and back of the squeegees clean. Use the Pick to scrape away any excess Core.
Thoroughly clean and dry the Service Station, Deck, Build Bed, and Front Over ow. Push the wiper
lever back to its original position.
infocenter.3dsystems.com/projetcjpx60/print/book/export/html/861
Don't get water in the front over ow or on the build bed.
Quick Start Guide
squeegees. Hold the lever and squirt water on
13/14