Table of Contents
Advertisement
8/11/22, 2:30 PM
Setting Up Your Printer
NOTE: Before starting your rst part, please ensure that the printer is clean and that it
is kept well-maintained. Please see the ProJet CJP 160, 260C, 260 Plus , 360 and
460 Plus User Guide for further instructions on properly cleaning your printer.
Add Binder
To add binder, follow the steps below.
Before inserting the cartridge into the
housing, check the expiration date,
and ensure the cartridge label is in the
correct orientation.
Insert cartridge into its housing. Ensure
it is pushed all the way in; you should
feel it gently snap into place.
Important:
into place, do not force it . Check the
orientation and that it is the correct type
of cartridge and try again.
If there is not enough binder in the
reservoir, 3DPrint displays
in the
Printer Status
Important:
are prompted to in
dialog.
infocenter.3dsystems.com/projetcjpx60/print/book/export/html/861
If a cartridge does not snap
BINDER LOW
dialog.
Do not add binder unless you
the Printer Status
Quick Start Guide
®
Add Core
To add Core, follow the steps below.
Open the printer cover and vacuum Core
into the feeder by selecting
the display. Important: Never use the
vacuum for any material other than
clean Core. Doing so will clog the
vacuum system.
3DPrint evaluates the geometry of the
part to determine if there is enough
Core in the Feeder to complete the build.
If there is not enough Core, 3DPrint
displays
ADD
CORE in the
dialog.
Important:
the Feeder unless you are prompted to
in the 3DPrint
Printer Status
The printer cannot start a print job when
the top cover is open; ensure cover is
closed before printing. Do not open the
cover while the machine is printing.
VACUUM
on
Printer Status
Do not add Core to
dialog.
6/14
Advertisement
Table of Contents
