Table of Contents
Advertisement
8/11/22, 2:30 PM
Fine Core Removal
Any loose Core on the part must be removed before proceeding
with post-processing.
160, 260C & 260
the external Cleaning Station. Open the Cleaning Station's top cover and
place the part onto the bed; close the top cover. Select
CLEANING
360 & 460 Plus Only:
the post-processing unit and close the top cover. Select
CLEANING
Test the air ow from the air wand against your hand and adjust as
needed. Turn the Control Knob left to decrease pressure, or right to
increase pressure.
Using the Air Wand, remove all remaining Core on the part. Use caution on
delicate areas. A small brush may also be gently used.
Push the Control Knob once to turn the air compressor off. Return the Air
Wand to its clip. If possible, allow the part to dry for several hours in the
post-processing unit.
infocenter.3dsystems.com/projetcjpx60/print/book/export/html/861
Plus: Open the printer's top cover and move the part to
on the LCD menu; the vacuum and compressor start.
Open the printer's top cover and place the part into
on the LCD menu; the vacuum and compressor start.
Quick Start Guide
EXTERNAL
VACUUM &
11/14
Advertisement
Table of Contents
