Vacuum & Cleaning - ProJet 60 Series Quick Start Manual

8/11/22, 2:30 PM
Finishing Build
Gross Core Removal
When the build is nished, you will need
to remove the Core around the part.
Automatic Core Removal (460 Plus Only)
When the build is nished, the printer
starts an automatic heated drying cycle.
A counter on the printer LCD counts
down the time remaining before the part
is dry.
If 'Empty Build Piston after Printing' is
selected prior to printing in the 'Printer
Station' window, the printer automatically
removes excess Core by vibrating the
Build Bed and vacuuming through the
bottom of the Build Bed.
Remove the part and carefully transfer it
to the Cleaning Station to clean the Core
from the part.
After all parts are removed, vacuum any
Core that may remain in the Build Bed.
infocenter.3dsystems.com/projetcjpx60/print/book/export/html/861
Quick Start Guide
Manual Core Removal (160, 260C,
260 Plus and 360)
When the build is nished, the printer
starts an automatic drying cycle (heated
on the 460 Plus , unheated on the 160,
260C, 260 Plus and 360). A counter on
the printer LCD counts down the time
remaining before the part is dry.
Select VACUUM & CLEANING
LCD menu. Open the cover. The
vacuum starts.
Vacuum Core from around the part.
Be careful around delicate sections.
Use the Control Knob to move the
Build Platform up as needed.
Carefully move the part to the
Cleaning Station to clean the Core
from the part.
After all parts are removed, vacuum
any Core that may remain in the Build
Bed.
on the
10/14