Audi TT 2019 Owner's Manual page 33

the functions of up to three hand-held transmit­
ters.
To operate the desired systems with the garage
door opener, you first need to program the but­
tons in the operating unit.
&
WARNING
When you are operating or programming the
garage door opener, make sure that no per­
sons or objects are close to the devices receiv­
ing the transmitter signals. Otherwise, per­
sons might be injured or other damage caused
by moving parts.
Note
- For security reasons we recommend that
you delete the programming of the buttons
prior to selling your vehicle.
- For more information about Homelink,
please see www.homelink.com.
How to use
Applies to: vehicles with garage door opener
Fig. 27 Operating unit above the interior mirror
Important: The button in the operating unit must
be programmed qpage 31 and the vehicle
must be within range of the garage door or other
system you wish to operate.
► To open the garage door, press the button. The
CD
green lED will light up or flash.
To close the garage door, press the button
►
again.
i
u
Note
<(
0
N
r--­
When opening/closing the garage door, do
N
.....
0 not keep the button pressed for more than
.....
l/)
co
20 seconds; otherwise the garage door open­
er will switch to the programming mode.
Programming the transmitter
Applies to: vehicles with garage door opener
Fig. 28 Distance between radiator grille and hand-held
transmitter
Programming a button: Stage 1 (at the
operating unit)
1. Switch on the ignition.
2. Press and hold down the two outer buttons
on the operating unitqpage31, Fig. 27until
the yellow LED @goes out and the green
CD
LED flashes. This procedure will delete the
standard factory settings and does
to be repeated when programming the other
buttons.
3. Briefly press the particular button on the op­
erating unit that you would like to program.
4. Wait until the yellow LED@flashes. The pro­
gramming mode is then activated for 5 mi­
nutes.
5. Step in front of your vehicle with the original
hand-held transmitter for the system you
wish to assign to the button on the operating
unit.
Programming a button: Stage 2 (at the
radiator grille)
Hold the hand-held transmitter in front of
6.
your car's radiator grille q Fig. 28.
7. Now press and hold the button on the hand­
held transmitter until the turn signals on
your vehicle start to flash. This can take up to
30 seconds.
8. If the hazard lights flash three times, the
button has been programmed successfully. If
the hazard lights flash once only, the
Doors and windows
not
need
►
31