Adjusting Graphic Display And Warning; Beeps; Fault Warnings - Audi TT 2019 Owner's Manual

Parking aids
After you select reverse gear, the vehicle has to
remain stationary for a moment so that the park
assist can activate the steering. Follow the direc­
tions given on the display.
■
Park assist: fault. Please contact workshop
■
Park assist: fault. Continue steering vehicle!
Please contact workshop
Please contact a qualified workshop. The park as­
sist cannot be used to park the vehicle if a system
fault occurs.
■
Park assist: cancelled. Space too small. Con­
tinue steering vehicle!
The park assist cannot be used to park the vehicle
in this space. Park the vehicle without using the
park assist or look for a bigger space.
Adjusting graphic display
and warning beeps
Applies to: vehicles with parking system plus/park assist
The settings for the graphic display and acoustic
signals are controlled via the infotainment sys­
tem.
► Select the following on the infotainment sys­
I I
button >Car> left control button
tem: MENU
> Driver assist> Parking aid.
Warning beeps
Front volume - Volume for the front and side*
zones
Rear volume - Volume for the rear zone
Entertainment fader -
audio or video source is reduced when the park­
ing aid is switched on.
(D
Note
- The settings will be automatically stored
and assigned to the remote control key in
use.
- You will hear a short tone* each time you
adjust the volume.
120
The volume of the current

Fault warnings

Applies to: vehicles with rear parking aid/parking system
plus/park assist
Rear parking aid: fault. Obstacles cannot be de­
tected
Parking aid: fault. Obstacles cannot be detected
If the LED in the P button starts flashing when
1!
1 1
you switch the system on, a system fault has oc­
curred. If the fault is not corrected before you
switch off the ignition, it will only be indicated by
the flashing LED in the PIJ/! button the next time
you switch on the parking aid by engaging re­
verse gear. The fault warning can be displayed in
the second tab of the driver information system
as long as the fault is active.
Parking system plus*/parking system plus
and park assist*
If a sensor or loudspeaker malfunctions, the Jl4
symbol will be shown on the infotainment sys­
tem in front of or behind the vehicle. If a rear
sensor malfunctions, obstacles will only be dis­
played in zones(!) and@
If a front sensor malfunctions, obstacles will only
be displayed in zones@and
Drive to a qualified workshop soon and have the
fault rectified.
page 112, Fig. 119.
q
©-