Optional Loconet® Bridge Module; Power Connections - PRICOM Design Layout Lighting Solution User Manual

Layout Lighting Solution – Starter Kit Assembly
4.4 Optional LocoNet® Bridge Module
For synchronizing to a LocoNet® Fast Clock, we have available an optional PNET to
LocoNet® Bridge Module. This module is both a PNET node as well as a LocoNet®
node. This Module listens to the LocoNet® and when it receives a Fast Clock update
(either fast clock setting, or fast clock broadcast) it translates the LocoNet fast clock to a
PNET fast clock packet.
Figure 18 - PNET to LocoNet® Bridge Module
The connections for the LocoNet® Bridge Module are quite easy. Simply connect the
LocoNet jack to your LocoNet, and the PNET jack to you PNET. You can loop your
PNET cable through either jack as they are both the same. The Mode Switch is not used
yet, so that is all there is to connecting this highly useful module!

4.5 Power Connections

Connect your Layout Lighting Main Board using the included 12VDC wall-transformer.
This process is discussed in the "Connections" section earlier in this manual.
The only other power connection needed is the appropriate 12VDC Power to the PNET
DC Power Controller Modules, covered in the Starter Kit Assembly section of this
manual. Since the 12VDC could be quite high current, it is worth double checking your
PRICOM Design Page 20