Table of Contents
Advertisement
Introduction
Receiving:
®
Inspect the Smartstart
damage is found, report it to the carrier immediately.
Remove cover of starter and visually check for damage.
Do not attempt to operate the Smartstart
obvious damage exists or suspect damage has occurred.
After the initial inspection, the Smartstart
repacked and stored in a clean, dry location until it is
required for use.
Handling & Storage:
To ensure the starter is protected before installation,
handle and store the equipment in its packaging.
DO NOT store this equipment in an area where the
ambient temperature will fall below -20ºC or rise above
70ºC. DO NOT store this equipment in areas that are
subject to condensation or corrosive atmosphere. Proper
storage is necessary to ensure satisfactory startup and
performance.
Handling on Installation:
®
The Smartstart
6000 range comprises 3 sizes with
various weights and dimensions.
An appropriate handling device must be used with large
starters. 'Handling points' have been provided to aid
lifting.
The precautions described below must be followed:
DO NOT handle the starter by the power
terminals/busbar.
Technical Manual: Smartstart
for any shipping damage. If any
®
if any
®
can be
®
6000
Use handling points where provided to lift larger
units.
Software:
This manual applies to the Smartstart
software revision R0.96K. The Software revision can be
viewed on the 'Dash Board' (Display) of the Smartstart.
Page 2
®
6000 series
IMI0042 rev D
Advertisement
Table of Contents
