Input/Output Functionality - Zener SMARTSTART 6000 Series User Manual

Programming
Table 1: Output Relay Functionality
Relay Function
Selection: Description
Line Ctrl Control for Line Contactor
Bypass Ctrl Control for Bypass Contactor
Starter in acceleration ramp
Accel Ramp
mode
Starter in deceleration ramp
Decel Ramp
mode
Ramping Starter in Ramp Mode
Up to Speed motor is up to speed
Motor On Motor is running
Trip Alarm A trip alarm is active
Bypass FLT Bypass contactor failed
Supply frequency range
Freq Error
exceeded
Output phase(s) Open
Mtr Loss
circuit/motor isolated
Remote Trip Remote trip active
SCR OL Trip SCR reached overload level
Mtr OL Trip Motor reached overload level
Motor thermistor/switch trip
Mtr OT Trip
active
Ph Rotation Rotation trip active
Remote Trip Remote trip active
Over time Over time trip active
Volt Imbal Voltage Imbalance trip active
Curr Imbal Current imbalance trip active
Under Current Under current trip active
Over Current Over Current trip active
Under Torque Under Torque trip active
Over Torque Over Torque trip active
Warning Alarm A warning alarm is active
Test (ON) Turns relay on
Technical Manual: Smartstart
®
6000
Table 2: Analogue Output Functionality
Analogue Output
Selection:
Mtr Torque
Mtr Thermal
SCR thermal
Active power
Power Factor
Mtr Current
Test (100%)
Page 26
Description
Estimated torque produced in
motor
Estimated Motor temperature of
over load
SCR temperature
Power consumed kW
Power Factor
Motor Current
Maximum output
IMI0042 rev D