Setup Menu - Outputs - Zener SMARTSTART 6000 Series User Manual

Programming
I22 DigIn 2 Delay
Set the delay that the digital input needs to be
active for the Soft starter to respond.
Range: 0.0 – 30.0 seconds
Default: -
To save changes
To exit without saving
Setup Menu
6 Outputs
Q10 Relay 1 Mode
Activates Relay 1.
Range: Enable; Invert; Disable
Default: Enable
To save changes
To exit without saving
Q11 Relay 1 Variable
Set the functionality of Relay 1.
Range: See table on page 26
Default: Line Ctrl
To save changes
To exit without saving
Q20 Relay 2 Mode
Activates Relay 2.
Range: Enable; Invert; Disable
Default: Enable
To save changes
To exit without saving
Q21 Relay 2 Variable
Set the functionality of Relay 2.
Range: See table on page 26
Default: Bypass Ctrl
To save changes
To exit without saving
Q30 Relay 3 Mode
Activates Relay 3.
Range: Enable; Invert; Disable
Default: Enable
To save changes
To exit without saving
Technical Manual: Smartstart
®
6000
Q31 Relay 3 Variable
Set the functionality of Relay 3.
Range:
Default:
To save changes
To exit without saving
Q40 Relay 4 Mode
Activates Relay 4.
Range:
Default:
To save changes
To exit without saving
Q41 Relay 4 Variable
Set the functionality of Relay 4.
Range:
Default:
To save changes
To exit without saving
Q50 An Out 1 Mode
Activate and set the signal type for Analogue
Output 1.
Range:
Default:
To save changes
To exit without saving
Q51 An Out 1 Variable
Set the functionality of Analogue Output 1.
Range:
Default:
To save changes
To exit without saving
Q52 An Out 1 FS (Full Scale)
Set the full scale of the Analogue output signal.
Range:
Default:
To save changes
To exit without saving
Example: 20mA = 400% Current
20mA = 200% Torque
Page 22
See table on page 26
Motor On
Enable; Invert; Disable
Enable
See table on page 26
Trip Alarm
Disabled ; 0-10v; 0-5v; 0-20mA;
4-20mA
Disabled
See table on page 26
Current
50 – 500%
200%
IMI0042 rev D