Programming; Local Control Panel - Zener SMARTSTART 6000 Series User Manual

Programming

Local Control Panel / Remote Console
The local control panel consists of 5 push buttons and
a plain English display to simplify programming.
Increase the value or change selection.
Navigate up through menu / submenus.
Decrease the value or change selection.
Navigate down through menu / submenus.
Allows access to menu, submenus & saves
the parameter entered.
Escapes from current menu position
without saving.
Manual reset of a trip (if enabled).
Operating Status Indication
Status / Fault displayed in
Plain English
Off
Bar Graph to provide
visual indication
'Off'
®
The Smartstart has control power applied but not
enabled.
'Standby'
®
The Smartstart has been enabled to start and the run
relay energized to bring in the line contactor (if
installed). The Smartstart
immediately 3 phase supply is applied. Supply Voltage
is displayed.
'Accel'
®
The Smartstart is accelerating the motor. Ramp time
completed (%) & Motor Current (A) displayed
'At Speed'
The motor is at full speed, the accel time period may
not be complete. Ramp time completed (%) & Motor
Current (A) is displayed.
'Run Bypass or Cont.' The ramp time is complete
and the bypass contactor operated or SCR's are in full
conduction. Motor Current (A) is displayed.
Technical Manual: Smartstart
Supply Voltage and
Motor Current
0A
0%
Bargraph Value
Default 'Motor current %'
®
will initiate a start
®
6000
'Decel'
®
The Smartstart
completed (%) & Motor Current (A) is displayed.
The Menu Map (Dash Board)
SMARTSTART 6000
6R030 r1.XX
Ready
140 SCR % Thermal
121 Mtr Capacity
415v 50Hz 100A
1-2-3 56kW
90% Torq 0.9PF
90% Pwr 56kW
Volt Imbal
415 415
Curr Imbal
100 100
0 Starts
0.8 RunHrs
400kw.Hrs
Last Trip
This symbol identifies the parameters for quick
setup.
Page 14
is decelerating the motor. Ramp time
ENTER
Main Menu
Esc
Note 1.:
100A
The default screen can be
changed. See menu item
80%
'D02 Default Screen'.
Note 2.:
The bargraph Variable can
be changed. See menu
item 'Bargraph var'.
Note 3.:
User Access to the menu
may be resticted. See
menu item 'D01 Menu
Access'.
0%
415V
0%
100A
0 Trip
IMI0042 rev D