Steps
1. Place the I/O board onto the palm-rest and keyboard assembly.
2. Align the ports and connectors on the I/O board to the slots on the palm-rest and keyboard assembly.
3. Align the screw holes on the I/O board to the screw holes on the palm-rest and keyboard assembly.
4. Replace the screw (M2x3) that secures the I/O board to the palm-rest and keyboard assembly.
5. Place the I/O-board cable on the palm-rest and keyboard assembly.
6. Connect the I/O-board cable to its connector on the I/O board and close the latch.
7. Connect the I/O-board cable to its connector on the system board and close the latch.
8. Connect the optional fingerprint-reader cable to the I/O board and close the latch.
NOTE:
This step is only applicable to computers shipped with a fingerprint reader.
Next steps
1. Install the
base
cover.
2. Follow the procedure in
Speakers
Removing the speakers
CAUTION:
The information in this section is intended for authorized service technicians only.
Prerequisites
1. Follow the procedure in
NOTE:
Ensure that your computer is in Service Mode. For more information see, step 6 in
computer.
2. Remove the
base
cover.
3. Remove the battery.
After working inside your
Before working inside your
computer.
computer.
Removing and installing Field Replaceable Units (FRUs)
Before working inside your
61